Analog module LKM752
LKM752
Analog part for the LKM75x radio system
The LKM752 can control four analog channels in conjunction with the LKM751 radio receiver. One 0...10V and one 4...20mA output is available per channel. The voltage and current output of the corresponding channel correspond with each other. This means that both outputs work in the same measuring range. The scaling of the analog outputs is configured with the receiver. The data is transferred to it from the receiver via an internal serial interface in the DIN rail. One receiver can operate up to two analog parts.
The measuring range is configured with the LKM751. If you would like a fully configured measuring range, please use the >>YOUR COMMENTS<< field at the end of the ordering process when you order an LKM751. Please observe the notes in the technical data.
| Number of analog channels | 4 | |
| Number of outputs | 8 | 4x current, 4x voltage |
| Output signal current: | 4...20mA | |
| Error | 0.062% FSR | 10µA |
| Max. Load: | 1000 Ohm | |
| Output signal Voltage: | 0...10V | |
| Error: | 0.017% FSR | 17mV |
| Max. Current load: | 2 mA | |
| Error message Current: | >20mA/<4mA | adjustable by software |
| Error message Voltage: | 0V/>10V | adjustable by software |
| Supply voltage: | 24 V DC 20% | reverse polarity protected |
| Current consumption: | 100mA | |
| Housing: | Polycarbonate | |
| Color: | grey | |
| Degree of protection: | IP20 | in clamping range |
| Terminal type: | Screw terminals | 0,2...2,5mm2 |
| Dimension: | 90x35x60mm | H x W x D |
| Weight: | 80g | with internal bus |
| Mounting: | top hat rail 35mm | |
| EMC: | EN 61326-1:2013 | Emission and noise immunity |
Documents
| Document | Format | Language(s) |
|---|---|---|
| Datasheet – LKM752 Technical Specification |
  |
|
| General operating instructions Radio system Installation and operating manual |
|
Software
| Program / Package | Format | Language(s) |
|---|---|---|
| Program – AnalogToTemperatur Conversion of analog output values (mA or V) to temperature |
ZIP | |
